Posts Tagged ‘Harris Ranch’

Harris Ranch Plumbing Tip: How to Increase Your Water Pressure

Friday, January 6th, 2012

It’s no fun when you are in the middle of taking a shower in your Harris Ranch home and the stream of water slows to a trickle. The most logical thing to blame the loss of water pressure is a toilet being flushed or a washing machine being filled. It is not uncommon for losses in water pressure to be associated with simultaneous water usage in other parts of the home.

But if low water pressure seems to be a constant problem when only one source is being used and there are no other appliances using water at the same time, you may have a bigger problem on your hands.

The first thing to do is to check the source of the water supply to your outdoor faucets. Turn the hose bibs to the fully open position and run the water. Is the pressure okay? If so, you probably have a problem indoors. While you are outside, check for any leaks in the hose bibs or faucets. A leak can cause a loss of water pressure in other plumbing circuits.

Now check the hose bibs on the lines leading to interior fittings, like faucets or showerheads, etc. Is the hose bib turned to the fully open position? Someone may have been playing with the bib and turned it down or off. If that checks out okay, take a look at all of the fittings in your plumbing fixtures. Are there any leaks? Is there standing water anywhere, indicating a leak?

If so, tighten up the affected fittings. If you need to remove any fittings to inspect or replace (i.e. a worn out washer or bushing), make sure you turn off the water supply to the fitting first.

If there are filter screens in your faucets check them for an accumulation of debris and clean if necessary. A clogged screen can greatly reduce water pressure.

Many new homes now come with a pressure regulator, which governs the water pressure going into the home. The regulator is located above ground, usually where the pipes enter the home. The pressures are usually preset by the regulator manufacturer but may not always be compatible to the local environment. If you think that may be the problem, contact a local plumbing professional for an opinion.

A disruption in the piping that feeds water into the home can also affect water pressure, such as tree roots in the pipes or a break in the line. These problems can only be diagnosed and corrected by qualified Harris Ranch plumbing professionals. Please do not attempt to find and fix these problems as the result may be costly or even dangerous to your health.

Low water pressure can be a drag but it may also only require a quick fix.

Tags: , , , , ,
Posted in Plumbing | Comments Off

What to Do if Your Heating System Breaks in Harris Ranch

Wednesday, November 30th, 2011

What if the heart of your Harris Ranch home’s heating system – the furnace – stops working? The warm air that used to flow from your vents has been replaced by a chilly draft. It isn’t time to panic, but it is time to take action. Before you do anything, determine why the furnace stopped working. It may be something as simple as a tripped circuit breaker in your electrical panel. Check the circuit breakers first.

The pilot light in your furnace may have blown out. It can be re-lit if you follow the directions in your furnace owner’s manual. You can find answers on how to re-light a pilot light on the Internet, too.

If the shutdown has not been caused by an electrical or pilot light failure, there is still no need to panic. But another obvious question is: did you pay your last gas bill? Maybe you had a shutoff notice and either ignored it or forgot about it.

Now that you are convinced that the furnace has pooped out, here are some things you should do. First, find the name of a qualified heating and cooling professional. If you already use a heating contractor, contact them and schedule a service call.

While you are waiting for help to arrive, ensure that everyone is safe and accounted for. Make sure pets are nearby and protected from the cold, too. What you don’t want to do is use any appliance to keep you warm that is not designed to keep you warm, like a stove. If you have electric space heaters or propane heaters, carefully locate them in a well vented room (windows open a bit or portable fans circulating air). You don’t want any build-up of gases from fossil burning appliances, gases which could contain deadly carbon monoxide.

Huddle up everyone into a room and break out lots of blankets. You may even want to make an “adventure” of this – find a movie to watch and pop up a bunch of popcorn.  If your waiting time is more than 24 hours, you might want to call up a friend or relative and make arrangements to spend the night with them.

The main thing to remember is not to panic. Most qualified heating contractors, knowing the circumstances, will send out a repair person in a matter of minutes or within one or two hours. Just remember to avoid keeping warm by using unvented heating devices.

Tags: , , , , ,
Posted in Heating | Comments Off

What Is a Water Source Heat Pump? A Question from Boise

Wednesday, October 12th, 2011

A water source heat pump operates much like a traditional air source heat pump except that it extracts and dissipates heat by way of water instead of air to heat your Boise home. This is certainly not a type of home comfort system that will be available to anyone, but if you live in an area close to a well, lake or other natural water source, it may be an option worth considering.

All types of heat pumps can provide excellent year round home temperature control by pumping heat in during the winter months and removing it during the summer. The main difference between the types of heat pumps is where they get the heat or dispose of it.

Traditional air source heat pumps get their heat from the air outside, as even relatively cold air actually contains a substantial amount of heat. They use this heat to keep your house warm in the winter, but as the outside temperatures go down below freezing, these heat pumps can become less and less effective.

Water source heat pumps, on the other hand, work on basically the same principle as air source heat pumps, but they extract heat from a body of water rather than the air. They do this by cycling water through a system of pipes that is laid out at the bottom of a body of water. As the water cycles through, it gathers heat from the lake or reservoir and then carries it back to your house.

In the summer, the process is reversed and heat is carried out of your house and expelled in the cooler water outside. Like air source heat pumps, water source heat pumps are slightly more efficient at cooling rather than heating, as even deep water will eventually get cold during the winter months. However, the water is still often warmer than the air, and so water source heat pumps can be a good alternative if you live in a slightly cooler climate.

Of course, you do also need to have access to an appropriate body of water to have a water source heat pump installed, which makes it something that is not available to everyone. But if you do live near such a body of water, a water source heat pump is definitely something worth considering.

Tags: , , , , , ,
Posted in Heat Pumps | Comments Off

The Beauty of Zone Heating: Some Advice From Dry Creek

Wednesday, October 5th, 2011

While it might not technically be a necessity, there are a lot of reasons why you might want to look into having a zone heating system installed in your Dry Creek home. Whether you’ve been using the same home heating system for a long time or are looking to have a new one installed, there’s never a bad time to have a zone heating system put in.

Most people think that the only thing that affects their home heating and cooling bills is the energy efficiency of their furnace or heat pump. However, that’s simply not always the case. Certainly, the more efficient your furnace or heat pump is, the lower your energy bills will be. But that doesn’t mean they’re as low as they could possibly be.

After all, if you don’t have a zone control system installed, you’re paying to heat your entire house every time you turn on the heat. Depending on the size of your house, that could mean you’re heating anywhere from two to 10 rooms or more that are unoccupied at the time. In fact, you could be paying to heat an entire empty wing of your home. And while you’ll pay less than you would if your heating system was less efficient, you’re still paying more than you need to.

With a zone control system, you can heat your home much more efficiently because you can control which areas of the house get the heat and which ones don’t. You can set multiple different temperatures for the different zones of your home, which allows you to keep the occupied areas warm while not forcing you to waste energy to heat unoccupied spaces.

Aside from the economic benefits of only heating the areas of your home that you need, zone control systems also can put an end to some of those contentious thermostat wars that go on in so many households. If the members of your household can never agree on what a comfortable temperature is, they can simply each set their own temperature for their own area of the house.

That way, everyone is happy and no one has to suffer uncomfortably. After all, you paid a lot for your state of the art home heating system. It’s only fitting that you should be able to get the most possible out of it.

Tags: , , , , ,
Posted in Heating | Comments Off

The Energy Efficiency Rating of Central Air Conditioners: What Is it and Why Is it Important in Dry Creek?

Friday, September 9th, 2011

When you are shopping for a central air conditioning system in Dry Creek, you will have to evaluate your options based on a number of different factors. For instance, you will need to decide which type of system is the best match for your home and for your particular cooling needs. It is also important to make sure that the central air conditioner you choose is the right size for the cooling load it will have to take on.

However, it is also very important to evaluate your central air conditioning options based on how energy efficient they are. This will have a great deal to do with how much you pay in terms of cooling costs each month, which makes it easy to see why you should take it into account before you make a purchase.

The energy efficiency of a central air conditioner is generally expressed as a seasonal energy efficiency rating, or SEER. The SEER numbers you will typically find on the latest air conditioning systems range from eight to 19.5 with the higher numbers signifying a more energy efficient model.

So it is pretty easy to figure out that a central air conditioner with a higher SEER will save you some money monthly because it will use less energy to get the same job done. But central air conditioners with high SEERs also typically have high price tags. So to determine how high of a SEER you need, you will need to know more exactly how much more money you will save as you move up in the rankings.

You can do this by comparing the SEER of the system you currently use with the new system you are considering and compare how much your current energy usage would cost you with each model. Basically, you want to pick a central air conditioner that will save you enough to offset the purchase price of the unit.

Often, this means that you will be best off with a SEER 14 or SEER 16 because these units save you a considerable amount over older models without carrying too high a purchase price. However, the amount you save will be directly related to how much you use your central air conditioning system, so if you live someplace that is extremely hot for a large chunk of the year, it may be worth it for you to buy a very high efficiency air conditioning system. If you need more information to decide which type of air conditioner is right for you, contact your local HVAC professional.

Tags: , , , , ,
Posted in Air Conditioning | Comments Off